Small LCD display on ST7735 driver with SPI interface. Square display 128x128 px.

Version NAM 0.3.3

Kit to solder, includes Wemos with Polish Firmware (can be changed after configuration). Includes SHT31/BMP180 instead of BME280. Has external WiFi antenna.

Това е стандартната версия, използвана в мрежата на AirBG.Info / Sensor Community. Версия с SHT31 вместо BME280

Slim plastic case for BBC micro:bit V2.

Slim plastic case for BBC micro:bit V2.

Slim plastic case for BBC micro:bit V2.

Slim plastic case for BBC micro:bit V2.

Slim plastic case for BBC micro:bit V2.

Slim plastic case for BBC micro:bit V2.

A specially designed cable with XH2.54 connectors for easy connection of the Sensor.Community kit

Small development board build on efficient ARM Cortex M0+ and LoRa radio! Build in GPS receiver and OLED screen.

Small 868 MHz antenna. Short cable with U.FL connector

LCD touch screen controlled by the SPI bus. Built-in SD card slot. Screen with a resolution of 480x320px.

Special cable for connecting the battery to CubeCell modules.

Core of NAM 0.3 ecosystem. Central unit with PM sensor, Wi-Fi connectivity (embedded antenna) and enclosure. Kit includes BMP180 & SHT31 sensors instead of BME280. Requires soldering.

Version NAM 0.3.3 - most recent

Core of NAM 0.3 ecosystem. Central unit with PM sensor, Wi-Fi connectivity (embedded antenna) and enclosure. Kit includes BMP180 & SHT31 sensors instead of BME280. Requires soldering.

Version NAM 0.3.3 - most recent

Small and powerful step-up converter. MicroUSB connector makes powering simple.

NodeMCU v3 (ESP-12E) developer module - no goldpins soldered. This is just MOD-1749 but no golpdin soldered

Large 868 Mhz antenna for LoRa modules

WiFi and Bluetooth enabled dev board based on ESP32. 38 PIN, wider PCB with mounting holese.

Custom housing for NAM 0.3.3

Sensor.community (aka Luftdaten) compatible kit - all components to build, soldered and programmed. NodeMCU with firmware with English language. NovaFitness SD011 and Sensirion SHT31 no barometric pressure readings.

Kit with dedicated harness cable, making sturdy connection.

If kit is not available, check BME280 version, which is preferred kit setup

Female contact to be used with ZHR socket. Both ends with contact.

Highly sensitive electrochemical O₃ sensor with a measurement resolution of less than 10 ppb (parts per billion). UART output. Powered from 5V power supply.

Pre-orders only

Highly sensitive electrochemical NO₂ sensor with a measurement resolution of less than 10 ppb (parts per billion). UART output. Powered from 5V power supply.

Pre-orders only

Connect your microcontroller with PC using wireless connection - HC-05 (master/slave). Works only on default settings (name - HC-05 and 9600 bauds)

A szálló por mérő megépítéséhez a teljes készlet

Small development board with LoRaWAN support. Designed for energy-effcient sensors.

LCD touch screen controlled by the SPI bus. Built-in SD card slot. Screen with a resolution of 480x320px.