Search results

Small GPS module with embedded antenna

Handy for solder removal

Terminal block, 2 pins, raster 2.54. Fit standard perf, proto and strip boards.

Terminal block, 3 pins, raster 2.54. Fit standard perf, proto and strip boards.

Rozszerz możliwości MyoWare Muscle Sensor

Zasil swój MyoWare Muscle Sensor

Nickel plated brass hex spacer 35 mm, Female-Female, M3,

MPU6050 - 3 axis gyroscope and 3 axis acclerometer

A small module with 3 axis accelerometer. Easy hookup with an Arduino (analog output). ±3g measurement range.

Small board with L293d and nodeMCU v2 socket.

Sewable LilyPad Arduino with native USB support

ATtiny84 that can be programmed with Arduino IDE, add wireless transmission, less than 5 µA during sleep - you can build wireless mesh of ie.temperature sensors with central unit that will collect all values.

RFID module RC522 - 13.56 MHz

Moduł 3-osiowego magnetometru i akcelerometru z interfejsem I2C

Rozświetl swój MyoWare Muscle Sensor

tinyProto - prototypes made easy! With green PCB.

Connect to Your Arduino or Raspberry LCD display using only 2 pins.

Jumper wires, M-M, 40 pcs, 20 cm

ESP-12F is a small module with WiFi on board lets You connect Arduino to Internet. But theres a lot more! This tinny board can work as standalone microcontroller with WiFi connectivity and 11 GPIO!

Goldpin 1x40, M-M, 18 mm height. Pins are in common 0.1” (2.54 mm) raster.

Small, compact - BMP180 - digital atmospheric pressure and temperature sensor. No matter if You are building weather station or drone this sensor will be handy. I2C interface and low power consumption (as low as 5 µA in standard mode and 0.1 µA in standby mode) make them a good choice for Your application.

Build your own Arduino shield!

GSM/GPRS module with two antennas. Supports SMS, GPRS, voice calls.

Relay module, 2 channels, 12V. Optocoupler. High/low level trigger.

Relay module, single channel, 12V. Optocoupler. High/low level trigger.

Proto shield for Arduino boards. Ready to use, soldered. As a bonus, You get small breadboard. You can prototype with wires on the breadboard and then get similar circuit soldered on proto board directly.

USB to Serial cable, Serial (UART) connector not in FTDI standard, just 4 flexible female pins.

Easy connect to Raspberry Pi (I2C) and get 4 analog inputs one analog output. Ready to use thermistor, photocell and potentiometer.

Passive elements set